Free EIAT Practice Questions

Question 1

At one training center, new apprentices completed a written checklist before operating a practice hoist. Supervisors initially believed the checklist slowed each session. Over four weeks, however, average setup time fell from 14 minutes to 10 minutes because trainees stopped repeating missed steps. The center kept the checklist and moved two lengthy explanations into a brief demonstration. Which statement best captures the passage's central point?

Accepted Answer

The checklist first seemed slower but ultimately reduced setup delays.

Answer

The center removed written directions to make every training session shorter.

Answer

Supervisors measured setup time during a four-week training period.

Answer

Brief demonstrations are always more effective than written instructions.

Question 2

A crew tested two carts on the same level floor. Each cart carried 240 pounds. Cart R required two workers to start moving. Cart S also required two workers before its wheels were lubricated, but only one worker afterward. Its load, floor, and starting method were unchanged between those two tests. What conclusion is best supported?

Accepted Answer

After lubrication, Cart S required less crew effort in the stated test.

Answer

Cart S can always carry more weight than Cart R.

Answer

One worker can move any 240-pound load on a level floor.

Answer

Both carts should be removed from use until their wheels are inspected.

Question 3

A heat-test instruction states: If the temperature rise is less than 3°F, continue the test for ten minutes and check again. If the rise is from 3°F through 5°F, pause the test and allow the unit to cool. If the rise exceeds 5°F or smoke appears, cut power and notify the supervisor. The recorded rise is 2.4°F, with no smoke. What should happen next?

Accepted Answer

Continue for ten minutes, then check the temperature again.

Answer

Cut power and notify the supervisor immediately.

Answer

Pause the test until the unit returns to its starting temperature.

Answer

Discard the reading and restart the test with a new baseline.

Question 4

A supervisor claims that a new storage layout reduced retrieval time. Before the change, five timed retrievals by a new employee averaged 7.8 minutes. After the change, five retrievals by an experienced employee averaged 6.1 minutes. Which evaluation is most defensible?

Accepted Answer

The results suggest improvement, but employee experience prevents assigning the change solely to the layout.

Answer

The layout definitely caused the faster retrievals.

Answer

Experienced employees always retrieve materials faster than new employees.

Answer

The layout had no effect because different employees performed the trials.

Question 5

Both repair plans would keep the line operating. Plan A could begin immediately, _____ it would require the line to run at reduced speed for the rest of the shift. Plan B would restore full speed but could not begin until tomorrow. Which word best completes the sentence?

Accepted Answer

but

Answer

therefore

Answer

similarly

Answer

because

Question 6

Before an inspection can begin, the work area must be cleared and the permit must be signed. The permit may be signed while the area is being cleared. Photographs are taken after the inspection, and the report is written only after the photographs are filed. At 8:10 a.m., the permit is signed, the area is still being cleared, and no inspection has occurred. Which task can begin as soon as the area is cleared?

Accepted Answer

Begin the inspection.

Answer

File the photographs.

Answer

Write the report.

Answer

Delay all work until a second permit is issued.

Question 7

A test card states: If a guard vibrates but remains latched, stop the cycle and tighten the latch before retesting. If the guard opens, or if smoke or sparking is seen, disconnect power and report the condition; do not restart. If neither condition occurs, record the result and continue. During a cycle, the guard remains latched but smoke appears. Which response follows the instruction?

Accepted Answer

Disconnect power, report it, and do not restart.

Answer

Tighten the latch, then restart after confirming it remains closed.

Answer

Record the result and continue testing.

Answer

Wait for the smoke to clear, then retest.

Question 8

Four external gears, A through D, are arranged in a straight line so that A meshes with B, B with C, and C with D. Gear A turns clockwise. How does Gear D turn?

Accepted Answer

Counterclockwise; three meshes mean three reversals.

Answer

Clockwise; each gear follows the gear before it.

Answer

Clockwise; four gears form an even-numbered train.

Answer

It cannot be determined without knowing every tooth count.

Question 9

Gear A meshes externally with Gear B. Gears B and C are rigidly fixed to the same shaft, and Gear C meshes externally with Gear D. Gear A rotates counterclockwise. Which motion trace is correct?

Accepted Answer

B clockwise, C clockwise, D counterclockwise

Answer

B clockwise, C counterclockwise, D clockwise

Answer

B counterclockwise, C counterclockwise, D clockwise

Answer

B clockwise, C clockwise, D clockwise

Question 10

A horizontal rack lies below a pinion gear. Viewed from the front, the pinion turns clockwise and does not slip against the rack. Which statement correctly describes the rack's motion?

Accepted Answer

It moves left because the pinion's lower surface moves left.

Answer

It moves right because the pinion's lower surface moves right.

Answer

It moves right because a rack follows the pinion's rotation.

Answer

It moves left because the pinion's upper surface moves left.

Free EIAT Practice Questions

Domain 1: Reading Comprehension 35% of exam

Question 1

Question 2

Question 3

Question 4

Question 5

Question 6

Question 7

Domain 2: Mechanical Aptitude 35% of exam

Question 8

Question 9

Question 10

The rest of the EIAT blueprint

That's 10 of 1,030